مرکز سازه های قاب فلزی سبک LSF

1. Attach DriftClip^® DSLS to structure with specified fasteners through step bushings.

2. Attach to stud with #12 provided screws through step bushings.

1. Fastener Pattern 1 replicates a condition of out-of-plane wind or seismic force with no vertical live load deflection and full in-plane drift.

2. Fastener Pattern 2 replicates a condition of out-of-plane wind or seismic force with full vertical live load deflection and full in-plane drift. 

Note: Allow a minimum of 0.875" from the structure to the inside flange of the bypassing stud to allow for track attachment.
One row of bridging is recommended at a maximum distance of 12" from DriftTrak to resist torsional effects.

1. Attach DriftClip^® DSLB to structure with specified fasteners through step bushings.

2. Attach to stud with #12 provided screws through step bushings.

1. Attach StiffClip HE to jamb with required number of screws.

2. Place header on shelf tabs of each StiffClip HE and attach clip to header with required number of screws.

3. Attach shelf ledge to header with required number of screws (if specified).

4. Attach bottom angle to jamb with required number of screws (if specified).

1. Place clip flush against wall stud flange and attach to stud with required amount of approved fasteners. Fastener amounts may vary by application.

2. Rest wood piece on shelf legs and attach to clip with required number of screws through guide holes. For higher loads, attach BackIt^® to the stud web through a guide hole in the interior leg.

1. To install the StiffClip RT, place one end flush against the roof framing member with the other end abutting the wall framing member.

2. Attachment includes 2 or 4 screws in the upper and lower parts of each StiffClip RT.

1. Place StiffClip WC at web of each framing member.

2. Attach StiffClip WC to framing member with required screws through guide holes

1. Place StiffClip FS flat against aligned wall studs.

2. Attach StiffClip FS to wall studs with approved screws through guide holes

1. Attach StiffClip HE to jamb with required number of screws.

2. Place header on shelf tabs of each StiffClip HE and attach clip to header with required number of screws.

3. Attach shelf ledge to header with required number of screws (if specified).

4. Attach bottom angle to jamb with required number of screws (if specified).